"The Ultimate Cheat Sheet" On Peugeot 308 Key Fob
Peugeot 308 Key Fob Replacement
Peugeot's 308 may be catching on a bit but it's still eye-catching. It's not the most luxurious vehicle in its class, but it is an enjoyable and relaxing driving experience.
Here at Coded Car Keys we are often asked to replace peugeot key fob reprogramming 308 key fobs. The following tips can assist whether the issue is intermittent, or constant.
Water Damage
If you accidentally drop your key fob in a puddle, or if it gets wet while kayaking canoeing, rafting, or canyoning it is likely to be damaged by water. Keep your key fob in a dry bag every time you are outdoors or engage in activities that could expose it to a lot of water.
It's also important to make sure the fob has completely dried before you open it up and then use it again. If you detect any odors emanating from the fob (such as industrial liquid or windshield washer fluid), this is another indicator that it is submerged.
A circuit board that's wet can cause the battery to discharge its charge, or even explode. If you're able, if you can, pull your key fob 308 out of the water in which it got stuck in then flip the button side down and shake it out as much water as you can before opening the case. When you've opened it, remove the battery, and then clean the circuit board with a cotton swab dipped in 90 percent isopropyl alcohol.
Other causes why your Peugeot 308 remote entry keyless system might not work could be due to a dead coin-cell battery or receiver module malfunction signal interference, or a faulty chip. If none of these are the cause you can restart the system by removing the 12 Volt battery from the car for 15 mins.
Dead Coin Battery
Peugeot cars are equipped with remote start technology that lets drivers start their car from the distance, allowing them to warm up or cool down the vehicle before they enter. This feature is extremely useful particularly during the cold winter months. However, sometimes the remote start system ceases working due to a variety of reasons, including a dead coin battery.
The coin-shaped battery inside the key fob will last between two and four months, depending on how often it's used, the location it was purchased and how it is used. The date of use is usually written on the package or marked in the manual.
If the key fob has stopped working after exposure to clean tap water and you want to remove the battery, clean the electronic chip using a paper towel and isopropyl alcohol, and then dry it thoroughly before replacing it. If you expose it to soapy or salty water, the chip could be fried and you will require replacing the key fob completely.
If you are not sure the battery is defective You can test the voltage with a multimeter that is set to the car's voltage range. Connect it to the terminals for minus and plus. The voltage should range from 12 to 13 volts, but if it is lower, the battery should be replaced. Alternately, you could try to reset the onboard computer by disconnecting the battery at 12 volts for a short period of time, and then reconnecting it in reverse order (positive cable first, then negative). The engine should start after this.
Faulty Receiver Module
If you're not seeing the "Key Detected" message on your dashboard, it's possible that the receiver module has been afflicted with a fault. It's the component that sends out an alert when the key fob turns on. It also functions as an alarm that stops the car from starting if it doesn't have the correct key.
The cause could be several factors, including water damage or simply aging. If the chip inside your Peugeot 308 keyfob has been damaged by dirty tap water it could be due to the fact that the keyfob was exposed to it. In this situation, you'll need to take the unit apart and thoroughly clean it with isopropyl alcohol or an electronic cleaner. Once it's dry, you can put the battery back in and test it again.
If the problem persists then it's a good idea to see an area Peugeot specialist or locksmith. They'll utilize a diagnostic tool to help pinpoint the issue and repair it for you.
Losing your peugeot remote key replacement keys to your car is an incredibly stressful experience. A qualified auto locksmith will be able to solve the issue in a matter of minutes. They can program your vehicle and cut a new peugeot key functioning key for you. Click here to find a local locksmith near you.
Faulty Electronic Chip
The chip in the Peugeot 308 key fob plays a crucial part in the remote control system. If the chip is damaged, you could be unable to start your car or receive a message stating "anti-theft". In this case the only option is to replace the key. Luckily, professional auto locksmiths can complete the task in the shortest amount of time.
The chip in your Peugeot 308 key fob can fail due to sweat, water damage, dirt or other reasons. If your Peugeot 308 key fob is exposed to soapy water, you must clean it immediately. You can clean the electronic component with paper towels soaked with isopropyl Alcohol. After that, you should let the battery dry completely.
Radio interference can cause a key fob to stop functioning. This is usually caused by other devices operate on the same frequencies as your peugeot expert key fob programming keyfob. It can also be caused by bad weather or objects around the vehicle. It is recommended that you visit a Peugeot dealer if you have this problem.
The Peugeot Key Fob 207/308 is delicate and needs special care. It is not recommended to drop it or throw it around. If you lose it, try to locate it as quickly as you can. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a few minutes. Make sure you disconnect the negative cable first, and then the positive.