What NOT To Do In The Peugeot 308 Key Fob Industry
Peugeot 308 Key Fob replacement key for peugeot 207
peugeot key programmer's 308 might seem a bit old however it's still attractive. It's not the most luxurious vehicle in its class, but it's a relaxing and civilised drive.
We get asked frequently at Coded Car Keys to replace peugeot key fobs. No matter if the issue is constant or intermittent these tips will aid.
Water Damage
If you accidentally drop your key fob in a puddle or it gets wet while kayaking, canoeing, rafting, or canyoning the fob is most likely to be damaged by water. The best way to prevent this from happening is to always keep it in a dry container when you're going outdoors or doing activities that require the fob to be exposed to a lot of water.
It's also crucial to ensure sure that the fob is completely dried out prior to opening it to use it again. If you detect any smells coming from the fob, such as an industrial-type liquid smell or the scent of windshield washer fluid, it's another sign that it's submerged in water.
A wet circuit board can cause the battery to lose its charge or even explode. If you can get your 308 keyfob out of the water you need to turn the button side up and shake as much water as possible before opening the casing. After you open it, take off the battery and wipe down the circuit board with a cotton swab dipped in 90-percent isopropyl alcohol.
Other reasons your Peugeot 308 remote keyless entry system that you use to enter your home may fail to function include an empty coin battery or receiver module issues, signal interference, or an electronic chip malfunctioning. If none of the above are the cause it is possible to reset the system by disconnecting 12 voltage battery from the car for 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote-start system that allows the driver to start the car from a distance while warming up or cooling down the vehicle prior to entering. This feature is extremely beneficial particularly in cold winter months. Remote start systems can be stopped for a variety of reasons, including a dead coin-battery.
The coin-shaped battery located inside the key fob could last between two and four years depending on how often it is used, the location it was purchased, and the way it is used. The date for use-by is typically printed on the packaging or in the manual.
If the key fob stopped functioning after exposure to clean tap water it is recommended to take the battery off, clean the electronic chip with a paper towel and isopropyl alcohol, and then dry it thoroughly before replacing it. If the key fob has been exposed to salty or soapy water, it could have caused the chip to become damaged. It is necessary to replace it.
If you're unsure whether the battery is damaged you can check its voltage using a multimeter attached to both the terminals plus and minus. If the voltage is lower than 12-13 volts you must replace the battery. Alternatively, you can attempt to reset the onboard computer by disconnecting the battery with 12 volts for a short period of time, and reconnecting it in reverse order (positive cable first, then negative). The engine should start.
Faulty Receiver Module
If you're unable to see the "Key Detected" message on your dashboard, it's possible that the receiver module has developed a fault. It's the component that sends out an alert when the key fob turns on. It also acts as an alarm and prevents the car from starting without the correct key.
This could be due to a range of causes, such as water damage or simply getting old. If the electronic chip within your Peugeot 308 keyfob is damaged by dirty tap water it could be due to the fact that the keyfob was in contact with it. In this case you'll need to remove the unit apart and thoroughly clean it with isopropyl or electronic cleaner. Once it's dry you can put the battery back in and test it again.
If the issue persists, it is a good idea that you visit the local Peugeot expert or locksmith. They can utilize the diagnostic tool to pinpoint the problem and repair it.
The loss of your Peugeot keys to your car can be an extremely stressful experience. A qualified auto locksmith can solve the problem within minutes. They can cut a brand new key and then program it into your vehicle, ensuring that you're off the road as fast as you can. Click here to find a local locksmith near you.
Faulty Electronic Chip
The electronic chip in the peugeot 206 new key 308 key fob is an crucial component of the remote control system. If the chip is damaged, you could have problems starting your car or get a message saying "anti-theft". In this scenario, the only solution is to replace the key. Luckily, professional auto locksmiths can complete the task within the shortest period of time.
The chip inside the key fob of your peugeot car keys 308 may fail due to many reasons, including sweat, water damage, or dirt. If your Peugeot key fob has been exposed to soapy or dirty water, it must be cleaned immediately. You can make use of a towel and isopropyl ethanol to clean the electronic component. Then, you need to let the battery completely dry.
Radio interference can cause the key fob to cease working. This could be due to other devices operate on the same frequency as your Peugeot keyfob. It could also be caused by weather conditions or objects that are in the vicinity of the vehicle. If you experience this problem it is recommended to visit an Peugeot dealership.
The Peugeot 208 Key Programming key fob 207/308 is very delicate and requires a lot of attention. It is crucial not to throw or drop the key fob. If you lose it, try to find it as quickly as possible. You can reset the onboard computer by disconnecting the battery for a few minutes. Disconnect the negative cable before the positive.